Navigation

TA101 Wind Anemometer Cup Set

CCU Extension Cable 15MMount your CCU farther than 3 m (9.8') away from the ECU with a 5m (16.4'), 15m (49.2'), or 25m (82.0') extension cable.WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer,...

B-60-20 Tilted Element TransducerLow profile tilted element for 16° to 20° deadrise hulls. Features: 600 WattsDual 50/200kHz

707/50/200T-CX Bronze Thru-Hull Transducer1kW, Bronze with temp recommended for deep water use (Beam angle: 14' x 21' @50kHz, 3' x 5' @200kHz)

The Clipper Wind system shares the same 110mm square case as its sister instruments in the Clipper range. the display is exceptionally large and clear, with 60 segments for full 360 degree direction indication. Windspeed is shown in knots, M.P.H. or...

Only 95g (0.21 lbs) Heel and pitch angle 30 degrees Calibration at the displays

The TR3K temperature probe is for use with the Maretron TMP100 Temperature Module (optional extra) or the DCM100 DC Monitor (it is included with the DCM100). This probe ends in a ring terminal and can be used to measure battery temperature or any other...

Mini Double Ended Cordset - Male to Female - 5M - GreyDouble-ended cordsets are used for trunk or drop lines and make for a secure connection and simple time saving installation. The connectors are keyed for error-free connection and are waterproof for...

ST60 Long Arm Masthead TransducerRaymarine's ST60 Long Arm Masthead Transducer comes with a 30m cable.

Mini Double Ended Cordset - Male to Female - 3M - GreyDouble-ended cordsets are used for trunk or drop lines and make for a secure connection and simple time saving installation. The connectors are keyed for error-free connection and are waterproof for...

Mini Double Ended Cordset - Male to Female - 1M - GreyDouble-ended cordsets are used for trunk or drop lines and make for a secure connection and simple time saving installation. The connectors are keyed for error-free connection and are waterproof for...

Termination Resistors are required on a NMEA 2000 network and are placed at each end of a network trunk cable. Like the double-ended cordsets, the termination resistors are waterproof and continue to function even while submerged in the bilge...