Navigation

Use this cable to connect a PB150, PB200, WX100 G2183, H2183 and GH2183 ro a NMEA2000® network.

Use our NMEA 2000 power isolator to ensure sources that could power the bus are separated properly during installation of the NMEA 2000 network.

Use our male NMEA 2000 field-installable connector to create custom-length drop cables and backbone extension cables. This connector can also be used to shorten any Garmin NMEA 2000 drop/backbone cable.

Use our inline terminator between the end of the backbone cable and your device to correctly terminate the network.

Use our female NMEA 2000 field-installable connector to create custom-length drop cables and backbone extension cables. This connector can also be used to shorten any Garmin NMEA 2000 drop/backbone cable.

Use our 2-pin replacement power cable with your GPSMAP® 4000/5000.

Use our 2 m (6.56 ft) NMEA 2000 power cable to provide power to your NMEA 2000 network.

Two termination resistors are required on every NMEA 2000 network, one on each end of the trunk line. Normally, a male termination is used since male pins tend to point back to the power source. In cases where the gender is reversed, a female terminator...

Two termination resistors are required on every NMEA 2000 network, one on each end of the trunk line. Normally, a male termination is used since male pins tend to point back to the power source. In cases where the gender is reversed, a female terminator...

Two termination resistors are required on every NMEA 2000 network, one on each end of the trunk line. Normally, a male termination is used since male pins tend to point back to the power source. In cases where the gender is reversed, a female terminator...

This mount attaches to any flat surface and is easily adjusted for optimal viewing. Screws not included.

This is a SeatalkNG starter kit consisting of T70134 STNG STARTER KIT Consisting of: A06064 STNG 5-WAY CONNECTOR A06031 STNG BACKBONE TERMINATOR (x2) A06040 STNG SPUR CABLE, 3M A06049 STNG POWER CABLE, 2M