Navigation

Use with PB200 to connect to Furuno Navnet and RD30 7-pin NMEA0183 port.

Use this power/data cable with your 400 and 500-series fishfinders and sounders. Not for use with chartplotters.

Use this cable with a NSS series MFD for video input

Use this cable to connect a PB150, PB200, WX100 G2183, H2183 and GH2183 ro a NMEA2000® network.

Use this cable to connect a PB150, PB200, WX100 G2183, H2183 and GH2183 ro a NMEA2000® network.

Use our NMEA 2000 power isolator to ensure sources that could power the bus are separated properly during installation of the NMEA 2000 network.

Use our male NMEA 2000 field-installable connector to create custom-length drop cables and backbone extension cables. This connector can also be used to shorten any Garmin NMEA 2000 drop/backbone cable.

Use our inline terminator between the end of the backbone cable and your device to correctly terminate the network.

Use our female NMEA 2000 field-installable connector to create custom-length drop cables and backbone extension cables. This connector can also be used to shorten any Garmin NMEA 2000 drop/backbone cable.

Use our 2-pin replacement power cable with your GPSMAP® 4000/5000.

Use our 2 m (6.56 ft) NMEA 2000 power cable to provide power to your NMEA 2000 network.

Two termination resistors are required on every NMEA 2000 network, one on each end of the trunk line. Normally, a male termination is used since male pins tend to point back to the power source. In cases where the gender is reversed, a female terminator...