Navigation

Two termination resistors are required on every NMEA 2000 network, one on each end of the trunk line. Normally, a male termination is used since male pins tend to point back to the power source. In cases where the gender is reversed, a female terminator...

Two termination resistors are required on every NMEA 2000 network, one on each end of the trunk line. Normally, a male termination is used since male pins tend to point back to the power source. In cases where the gender is reversed, a female terminator...

This mount attaches to any flat surface and is easily adjusted for optimal viewing. Screws not included.

This is a SeatalkNG starter kit consisting of T70134 STNG STARTER KIT Consisting of: A06064 STNG 5-WAY CONNECTOR A06031 STNG BACKBONE TERMINATOR (x2) A06040 STNG SPUR CABLE, 3M A06049 STNG POWER CABLE, 2M

This has a RayNet Female connector at one end and a RJ45 Female Gland connector at the other end. The Gland makes the RJ45 Female socket watertight. A typical use for this cable would be to convert a "RJ45" Digital Radar Cable to a "RayNet" Radar Cable,...

This 4 meter cable has a female micro C NMEA2000® connector on one side and a simnet connector on the other.

This 1 meter cable has a female micro C NMEA2000® connector on one side and a simnet connector on the other.

The Raynet to RJ45 Ethernet (M) adapter can be used to connect new c and e-Series MFDs to the SR6 or 8-Port Seatalk High Speed network switch. When used in conjunction with a crossover coupler, this adapter can also convert the Ethernet connection on a...

The Raynet to RJ45 Ethernet (M) adapter can be used to connect new c and e-Series MFDs to the SR6 or 8-Port Seatalk High Speed network switch. When used in conjunction with a crossover coupler, this adapter can also convert the Ethernet connection on a...

The Raynet to RJ45 Ethernet (M) adapter can be used to connect new c and e-Series MFDs to the SR6 or 8-Port Seatalk High Speed network switch. When used in conjunction with a crossover coupler, this adapter can also convert the Ethernet connection on a...

The new RayNet (Male) to RayNet (Male) Cable Joiner adapter lets you connect 2 standard RayNet networking cables together in instances where you need to extend the length of a cable run. The cable is 3.9-inches (100mm) long.

The new Raynet (Female) to SeaTalkhs (Male) cable allows to directly connect your G-Series, E-Wide, C-Wide and E-Classic MFDs to new generation RayNet radar, sonar or other accessory that utilises the new RayNet connection. The adapter cable is 10 feet...